MDX V6-3.7L (2007)
14. When the No.1 LED stays on and the No.2 LED goes off, turn the ignition switch to LOCK (0).
15. Turn the ignition switch to ON (II). When the No.1 and No.2 LEDs stay on, the control unit/module is updated.
16. Turn the ignition switch to LOCK (0), and disconnect the DLC cable from the vehicle. To do the same update on an identical vehicle, repeat steps
11 thru 16.
UPDATING WITH THE HDS TABLET AND THE HDS POCKET TESTER
NOTE:
This procedure explains how to update with the HDS tablet. Updating with the HDS pocket tester is similar, but the user interface is modified to fit
its smaller screen.
1. If not already done, load the latest HDS PC software onto your HDS tablet or HDS pocket tester. Refer to the instructions included with the HDS
Installation Disc.
NOTE:
If the latest software is not loaded and you do a control unit/module update, the software may indicate the vehicle has the latest update when it
doesn't. Updates not done with the latest software are not covered under warranty.
2. On the HDS Switchboard screen, click on the CM update icon.
