MDX V6-3.7L (2007)
9. Click on the check mark to begin the control unit/module update.
NOTE:
To avoid control unit/module damage, do not interrupt the update.
10. Within 60 seconds of update completion, turn the ignition switch to LOCK (0) and then back to ON (II).
11. Once the software verifies that the control unit/module has been successfully updated, click on Yes to update another identical vehicle, or click on
No to exit the update program.
HIM Updating in Storage Mode
NOTE:
If the red No.3 on the HIM comes on or flashes during the update, go to Diagnosing HIM Error Codes.
1. If not already done, load the latest HDS PC software onto your iN workstation. For loading instructions, refer to the Tool Information publication
Installation Instructions for HDS PC Software on ISIS.
NOTE:
If the latest software is not loaded and you do a control unit/module update, the software may indicate the vehicle has the latest update when it
doesn't. Updates not done with the latest software are not covered under warranty.
2. From the iN workstation desktop, select CM Update (ECU Rewrite).
3. Click on the tools button on the right side of the screen, and make sure the interface device is set to HIM.
4. Return to the Updating Honda Control Modules main screen, then click on Storage Mode and follow the on-screen instructions.
5. Take the HIM to the vehicle, and connect it to the vehicle's DLC.
