MDX V6-3.7L (2007)
20. Replace the gasket with new one when installing the solenoid valve cover.
21. Disconnect the connectors from shift solenoid valve A, shift solenoid valve B, shift solenoid valve C, and shift solenoid valve D.
22. Measure the resistance of each shift solenoid valve between the connector terminal and body ground.
Standard: 12-25 Ohms
^
If the resistance is out of standard, go to step 25 and replace shift solenoid valve.
^
If the resistance is within the standard, go to step 23 and check solenoid valve for a clicking sound.
23. Connect a jumper wire from the negative battery terminal to the body ground, and connect another jumper wire from the positive battery terminal
to each solenoid valve terminal individually.
^
If a clicking sound is heard, go to step 24 and replace the shift solenoid harness.
^
If no clicking sound is heard, go to step 25 and replace shift solenoid valve.
24. Remove the shift solenoid harness connector (A) and replace it. Install a new O-ring (B) on the shift solenoid harness connector, and install the
connector in the transmission housing, then go to step 31.
