MDX V6-3.7L (2007)
Repairs and Inspections Required After a Collision: Service and Repair
SRS Component Replacement / Inspection After Deployment
Component Replacement/Inspection After Deployment
NOTE:
-
Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions for the less obvious deployed parts (
seat belt tensioners, front impact sensors, side airbag sensors, etc.)
-
Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting.
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioners
-
Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side airbag(s)
-
Reinforcing cloth rear hooks
-
Side impact sensor(s) (first) for the side(s) that deployed
-
Side impact sensor(s) (second) for the side(s) that deployed
-
B-pillar lower trim
-
Complete seat frame
After a collision where the side curtain airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Seat belt tensioner(s) for the side(s) that deployed
-
Side impact sensor(s) (first) for the side(s) that deployed
-
Side impact sensor(s) (second) for the side(s) that deployed
-
Satellite safing sensor
-
Roll rate sensor
-
Roof trim
-
A-pillar trim
-
B-pillar upper trim
-
Quarter pillar trim
-
Front grab handle
-
Rear grab handle
-
All related trim clips
-
Sunvisor