MDX V6-3.7L (2007)
5. Inflate the tire to 300 kPa (3.1 kgf/cm2, 44 psi) to seat the tire bead to the rim, then adjust the tire pressure.
NOTE: Make sure the tire bead is uniformly seated on both sides of the rim.
6. Check the valve stem nut tightening torque, then install the valve stem cap.
7. Check and adjust the wheel balance, then install the wheels on the vehicle. Torque the wheels to specifications.
8. Remove the jack stands, and lower the vehicle.
9. Connect the HDS and memorize the tire pressure sensor ID(s).
