MDX V6-3.7L (2007)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
Transmission Range Switch Replacement
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery cover, battery, and battery tray.
4. Remove the under-hood subfuse box from its bracket, and remove the bracket from the battery base.
5. Remove the intake air duct and air cleaner housing.
6. Remove the battery base and battery base bracket.
7. Remove the nuts securing the shift cable bracket (A).
8. Remove the spring clip/washer (B) and control pin (C) then separate the shift cable end (D) from the control lever (E).
9. Check the synthetic resin bushing (F) in the shift cable end for a proper fit and wear. If the bushing is loose or worn, replace the shift cable.
10. Disconnect the transmission range switch connector.
11. Pry the lock tab of the lock washer (A) on the control lever (B) and remove the nut (C) lock washer, spring washer (D) and control lever.
12. Pry the lock tabs of the lock washer (E) on the transmission range switch (F) hold the control shaft (G) with a 6.0 mm wrench, and loosen the
locknut (H).
13. Remove the locknut and lock washer, then remove the transmission range switch (two bolts).
14. Set the new transmission range switch (A) to the N position. The transmission range switch clicks in the N position, and the control shaft hole (B)
aligns with the N position line (C).
