MDX V6-3.7L (2007)
4. Position the terminal in the crimping tool slot with the solid portion of the terminal toward the anvil and the open section toward the former.
5. Insert the wire in the terminal to the position shown in step 3.
6. Squeeze the tool with both hands until the stops make contact.
7. Crimp the insulation crimp.
-
If you do not have a wire seal, then use the next larger size crimp slot. Position the crimping tool over the insulation crimp section of the
terminal, then squeeze the tool with both hands until the stops make contact.
-
If you have a wire seal, position the insulation crimp in the 5.5 crimping slot, then carefully squeeze the crimp closed until its ends are
touching and making a full-circle shape.
