MDX V6-3.7L (2007)
5. Insert the pigtail terminal into the connector cavity; push it in until it locks in place.
6. Lay the pigtail and the original wire side-by-side, and cut off both ends at once. If you are making more than one splice, do not cut each pigtail at
the same location; the resulting lump of splice connectors would interfere with rewrapping the harness. Instead, cut the first pigtail close enough to
the terminal so you will have room to make each remaining cut about 20 mm (3/4 inch) farther down on the next pigtail.
7. If you are using a yellow splice connector, strip about 6 mm (1/4 inch) of insulation off the ends of both wires. If you are using a pink or blue
splice connector, strip off about 8 mm (5/16 inch) of insulation.
NOTE: If you nick or cut off any strands of wire, try again with the next larger size hole on the stripper.
