MDX V6-3.7L (2007)
PARTS INFORMATION
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number:
1161D3 (one or more keyless
remote modules)
Flat Rate Time:
0.4 hour
Failed Part:
P/N 72147-SOK-A23
Defect Code:
03217
Symptom Code:
08201
Skill Level:
Repair Technician
REPAIR PROCEDURE
NOTE:
Make sure to use a # 0 Phillips Screwdriver that is in good condition, and apply enough down force when removing the screw to avoid damaging the
screw.
1. Using a # 0 Phillips screwdriver, remove the screw from the key case. Remove the cover and the key transmitter.
2. Follow the Decode and Copy instructions on the Matrix X key cutter to cut a new key with the new key case. This allows you to use the original key
without needing the key code.
3. Assemble the cover and the transmitter onto the new key case, and install the screw.
4. To add a key with the HDS, you need these items:
^
The new master key
^
First password (this five character code is available on the iN. Go to SERVICE, select Vehicle Information from the left column, then select
Immobilizer Code Inquiry.
^
HDS with software 2.020.018 or later.
NOTE:
Make sure the market, the date, and the time on the HDS setup screen are correct. Select the F12 key in the upper right corner to get the Set-up
Details screen. Make sure Market is set to USA. Select the time display in the lower right corner to get the Date/Time Properties pop-up window.
Make sure the date and time are correct. For details, refer to the HDS Set-up Instructions listed under Tool Information in ISIS.
5. Connect the HDS to the DLC (data link connector).
6. Insert the client's original key (now without the keyless transmitter) into the ignition switch, and turn the switch to ON (II). Turn on the HDS.
7. At the screen prompts, enter the VIN and the odometer reading, then verify the correct date and time.
