MDX V6-3.7L (2007)
19. Position the pump driveshaft (A) in the pump housing, then press it in with the appropriate size socket wrench (B) as shown.
20. Install the 40 mm snap ring (C) with its beveled edge facing out.
21. Coat the new pump cover seal (A) with power steering fluid, and install it into the groove in the pump cover (B).
22. Install the outer side plate (C) over the two roll pins (D) with its arrow marks stamped (E) facing down.
23. Set the cam ring (A) over the two roll pins with the "." marks (B) facing down.
24. Install the rotor (A) to the pump cover (B) with its "." mark (C) facing up.
