MDX V6-3.7L (2007)
Ball Joint: Service and Repair
Front and Rear Suspension
Ball Joint Removal
Special Tools Required
^
Ball joint remover, 32 mm 07MAC-SL0A102
^
Ball joint remover, 28 mm 07MAC-SL0A202
NOTICE: Always use a ball joint remover to disconnect a ball joint. Do not strike the housing or any other part of the ball joint connection to
disconnect it.
07MAC-SL0A102 or 07MAC-SL0A202
1. Install a hex nut (A) onto the threads of the ball joint (B). Make sure the nut is flush with the ball joint pin end to prevent damage to the thread end
of the ball joint pin.
2. Apply grease to the ball joint remover on the areas shown (A). This will ease installation of the tool and prevent damage to the pressure bolt (B)
threads.
3. Loosen the pressure bolt (A) and install the ball joint remover as shown. Insert the jaws carefully, making sure not to damage the ball joint boot.
Adjust the jaw spacing by turning the adjusting bolt (B).
NOTE: Fasten the safety chain (C) securely to a suspension arm or the subframe (D). Do not fasten it to a brake line or wire harness.
