MDX V6-3.7L (2007)
Installation
1. Clamp the new damper housing (A), front wheelhouse (B), bulkhead side member (C), front end outrigger (D), and front bulkhead (E). Measure
the front compartment diagonally.
2. Check the body dimensions.
-
Engine compartment
-
Engine side mount position
-
Bulkhead side member position
-
Engine compartment and front floor under view
-
Repair chart, top view
-
Repair chart, side view
3. Tack weld the new parts and front bulkhead into position.
4. Temporarily install the front subframe, and check the front side frame position.
5. Temporarily install the hood, front fender, headlight, and front bumper, then check for differences in level and clearance. Make sure the body lines
flow smoothly.
6. Do the main welding. Weld the damper housing (A) and wheelhouse lower gusset (B) to the front side frame (C).
