MDX V6-3.7L (2007)
3. Remove the cotter pin (A) from the tie-rod ball joint, then remove the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
4. Disconnect the tie-rod ball joint from the knuckle using the ball joint remover.
5. Remove the cotter pin (A) from the lower arm ball joint pin (B) then remove the nut (C).
NOTE: During installation, install the lock pin after tightening new castle nut.
6. Install the ball joint thread protector (D).
7. Disconnect the lower arm ball joint from the knuckle using the ball joint remover.
8. Remove the damper pinch bolts (A) and flange nuts (B) from the damper, then remove the knuckle (C).
NOTE: During installation, install new damper pinch bolts and new flange nuts.
