MDX V6-3.7L (2007)
6. Remove the two 6 x 1.0 mm screws (A) attaching the disc/drum to the hub bearing unit. Release the parking brake, and remove the brake
disc/drum from the hub bearing unit.
NOTE:
^
It may be necessary to back-off the parking brake adjuster nut (B) to remove the disc/drum from the hub bearing unit.
^
If the brake disc/drum has clung to the hub bearing unit. Screw two 8 x 1.25 mm bolts (C) into the brake disc/drum to push it away from the
hub bearing unit. Turn each bolt 90 degrees at a time to prevent cocking the brake disc/drum.
^
After installation, check the parking brake, and adjust it necessary.
7. Remove the hub bearing unit (A).
8. Check the hub bearing unit for damage and cracks.
9. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Tighten all mounting hardware to the specified torque values.
^
Use a new spindle nut during reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc/drum, clean the mating surface of the hub bearing unit and the inside of the brake disc/drum.
^
Before installing the wheel, clean the mating surface of the brake disc/drum and the inside of the wheel.
