MDX V6-3.7L (2007)
Pressure Regulating Solenoid: Testing and Inspection
A/T Clutch Pressure Control Solenoid Valve A Test
A/T Clutch Pressure Control Solenoid Valve A Test
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid A in the Miscellaneous Test Menu on the HDS.
NOTE: If the HDS does not communicate with the PCM, troubleshoot the DLC circuit.
3. Test A/T clutch pressure control solenoid valve A with the HDS.
^
If the valve tests OK, the test is complete. Disconnect the HDS.
^
If the valve does not test OK, follow the instructions on the HDS.
^
If the valve does not test OK, and the HDS does not determine the cause, go to step 4.
4. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
5. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
6. Remove the battery hold-down bracket, and remove the battery cover, battery, and battery tray.
7. Remove the under-hood subfuse box from its bracket, and remove the bracket from the battery base.
8. Remove the intake air duct and air cleaner housing.
9. Remove the battery base and battery base bracket.
10. Disconnect the A/T clutch pressure control solenoid valve A connector.
11. Measure A/T clutch pressure control solenoid valve A resistance at the connector terminals.
Standard: 3-10 Ohms
^
If the resistance is out of standard, replace A/T clutch pressure control solenoid valve A.
^
If the resistance is within the standard, go to step 12.
12. Connect a jumper wire from the negative battery terminal to the solenoid valve A connector terminal No. 2, and connect another jumper wire from
