MDX V6-3.7L (2007)
19. Remove the bolt securing the harness cover (D) and disconnect the 4th clutch transmission fluid pressure switch connector (E).
20. Remove the A/T clutch pressure control solenoid valve A and B, ATF pipes (C), gasket (D), and O-rings (E).
21. Check the fluid passage of the solenoid valve for contamination.
22. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve B connector terminal No. 2, and connect
another jumper wire from the positive battery terminal to the connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve B
moves.
23. Disconnect one of the jumper wires and check valve movement at the fluid passage in valve body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve A and B.
24. Clean the mounting surface and fluid passage of the solenoid valve body and solenoid valve cover.
25. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install the new O-rings over the ATF pipes.
26. Install A/T clutch pressure control solenoid valve A and B.
27. Secure the harness cover with the bolt.
28. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
29. Apply molybdenum grease to the bore hole of the synthetic resin bushing in the shift cable end, and attach the shift cable end to the control lever,
