MDX V6-3.7L (2007)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft Installation
Propeller Shaft Installation
1. If you are installing a new propeller shaft, go to step 2. If you reinstalling the original propeller shaft, go to step 3.
2. Install the new propeller shaft (A) onto the rear differential (B) by aligning the reference mark (C) on the new propeller shaft with the factory
reference mark (D) on the companion flange (E). Do not use the marks you made on the companion from the removal procedure. If there are no
factory marks on the companion flange, go to step 4.
3. Reinstall the No. 2 propeller shaft (A) to the rear differential (B) by aligning the reference marks (C) you made during the removal procedure.
4. Attach the No. 2 propeller shaft to the rear differential with new mounting bolts. Tighten the bolt to the specified torque.
5. Install the center support bearing mounting bolts. Make sure you use new bolts.
6. Install the No. 1 propeller shaft (A) onto the transfer companion flange (B) by aligning the reference mark (C). Make sure you use new mounting
bolts.
