MDX V6-3.7L (2007)
5. Using a wrench on the winding mandrel of the boot band tool, tighten the band until the marked spot (C) on the band meets the edge of the clip.
6. Lift up the boot band tool to bend the free end of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
7. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5-10 mm (0.2-0.4 in.) tail protruding from the clip.
8. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything on the vehicle and that the band does not move.
^
Clean any grease remaining on the surrounding surfaces.
