MDX V6-3.7L (2007)
the positive battery terminal to the connector terminal No. 1.
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 13.
13. Remove the nuts securing the shift cable bracket (A).
14. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
15. Check the synthetic resin bushing (F) in the shift cable end for a proper fit and wear. If the bushing is loose or worn, replace the shift cable.
16. Disconnect the transmission range switch connector (A) input shaft (mainshaft) speed sensor connector (B) output shaft (countershaft) speed
sensor connector (C) 3rd clutch transmission fluid pressure switch connector (D) and ATF temperature sensor connector (E).
17. Remove the harness clamp (F) from the clamp bracket (G).
18. Disconnect the A/T clutch pressure control solenoid valve A connector (A) A/T clutch pressure control solenoid valve B connector (B) and shift
solenoid harness connector (C).
