MDX V6-3471cc 3.5L (2002)
8. Disconnect and detach the connector (A) and harness clip (B) from the door. Remove the bolts (C), and loosen the bolts (D), then remove the
regulator (E) through the hole in the door.
9. Grease all the sliding surfaces of the regulator (A) where shown.
10. Install the door glass, quarter glass, and regulator in the reverse order of removal, and note these items:
-
Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
