MDX V6-3471cc 3.5L (2002)
Paint: Service and Repair
Top Coating
Top Coating
1. Masking
Mask the area surrounding the damage to protect it from the top coat overspray.
2. Spraying top coat enamel / clear coat
Spray 2 to 3 coats until the intermediate coat is fully covered.
NOTE:
-
Do not cover the surface with one heavy coat.
-
Apply several thin coats.
-
Use the 2-part polyester urethane top coat enamel and a spray gun.
-
Mix the top coat enamel with the additive and solvent in the correct ratio.
-
Follow the top coat manufacturer's instructions.
After spraying the top coat enamel, allow for 5 to 10 minutes drying time before you spray the clear coat.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
After spraying the clear coat, allow for 5 to 10 minutes drying time before you force dry it with infrared lamps or other industrial dryer.
3. Polishing / buffing
-
Check that the clear coat has dried thoroughly.
-
Wet sand to remove any imperfections.
Use a flexible block, soap, and #2000 sandpaper.
-
Using a buffer and compound, remove any polishing marks made from the sandpaper.
Use a buffing sponge, and buffing wool and compounds.
Finish up with buffing:
-1. Wet sand with #2000 sandpaper and soapy water.
-2. Remove moisture using compressed air.
