MDX V6-3471cc 3.5L (2002)
Brake Caliper: Service and Repair
Rear
Rear Brake Caliper Overhaul
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
-
Avoid breathing dust particles.
-
Never use an air hose or brush to clean brake assemblies. Use an OSHA- approved vacuum cleaner.
Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:
-
Do not spill brake fluid on the vehicle; It may damage the paint; If brake fluid gets on the paint, wash it off immediately with water.
-
To prevent dripping brake fluid, cover disconnected hose joints with rags or shop towels.
-
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
-
Before reassembling, check that all parts are free of dirt and other foreign particles.
-
Replace parts with new ones as specified in the illustration.
-
Make sure no dirt or other foreign matter gets into the brake fluid.
-
Make sure no grease or oil gets on the brake discs or pads.
-
When reusing pads, always reinstall them in their original positions to prevent loss of braking efficiency.
-
Do not reuse drained brake fluid. Use only clean Genuine Honda DOT 3 Brake Fluid. Non-Honda brake fluid can cause corrosion and shorten
the life of the system.
-
Coat the piston, piston seal groove, and caliper bore with clean brake fluid. Replace all rubber parts with new ones.
-
After installing the caliper, check the brake hose and line for leaks, interference, and twisting.
