MDX V6-3471cc 3.5L (2002)
Vacuum Brake Booster: Service and Repair
Brake Booster Replacement
1. Remove the master cylinder.
2. Remove the cable bracket (A) from the throttle body, then disconnect the throttle cable end (B) and actuator cable end (C) from the throttle
linkage.
3. Disconnect the vacuum hose (D) from the brake booster (E).
4. Remove the lock pin (A) and joint pin (B).
5. Remove the brake booster mounting nuts (C).
6. Pull the brake booster (A) forward, and remove it from the engine compartment.
7. Install the brake booster in the reverse order of removal, and note these items:
-
Adjust the pushrod length before installing the brake booster.
-
After installation, adjust brake pedal height and brake pedal free play.
-
After installation, check for cables free play, and adjust actuator cable or throttle cable if necessary.