MDX V6-3471cc 3.5L (2002)
12.
Remove the four nuts and bolts holding the retaining bracket to the new engine mount, and remove the retaining bracket.
13.
Position the engine mount on the subframe. Install the engine mount bolts loosely.
14.
Install the retaining bracket on the engine mount.
15.
Install the front bracket and the passenger-side bracket bolt, threading it halfway in.
16.
Torque all four engine mount bolts to 34 Nm (25 lb-ft).
17.
Reconnect the vacuum line.
18.
Lower the transmission, and remove the floor jack. Install the four retaining bracket nuts and bolts, and torque them to 22 Nm (16 lb-ft).
19.
Install the remaining two bolts to the front bracket, and torque them to 38 Nm (28 lb-ft).
20.
Install and torque the top engine mount nut to 54 Nm (40 lb-ft).
