MDX V6-3471cc 3.5L (2002)
8.
Install the new auto-tensioner. Refer to section 6 of the appropriate service manual.
NOTE:
Replace the dipstick tube 0-ring.
9.
Remove the pin from the auto-tensioner and the wire ties from the cam pulleys.
10.
Install the remaining parts in the reverse order of removal. Tighten all nuts and bolts to the specifications shown in the appropriate service manual.
NOTE:
Overtightening the power steering belt would cause the power steering pulley to fail, so make sure you set the belt tension to the used belt
specification. Refer to section 17 of the appropriate service manual.
11.
If you replaced the water pump, the timing belt, and the auto-tensioner, center-punch completion marks above the second and the sixth characters
of the engine compartment VIN. If you replaced only the auto-tensioner, center-punch a completion mark above the sixth character of the engine
compartment VIN.
Water Pump, Timing Belt, and Auto-Tensioner:
Disclaimer
