MDX V6-3471cc 3.5L (2002)
14. Using the Backprobe Set, measure the voltage between the No.27 terminal of PCM connector A (32P) and body ground with the PCM connectors
connected.
Is there battery voltage?
YES - Check for loose wires or poor connections at PCM connector A (32P). If the connections are good, substitute a known/good PCM, and
recheck. If the symptom/indication goes away, replace the original PCM.
NO - Repair open in the wire between the PCM and the A/C pressure switch.
15. Disconnect the jumper wire.
16. Disconnect the compressor clutch 1P connector.
17. Check for continuity between the No.2 terminal of the compressor clutch relay 4P socket and the No.1 terminal of the compressor clutch 1P
connector.
Is there continuity?
YES - Check the compressor clutch clearance and the compressor clutch field coil.
NO - Repair open in the wire between the compressor clutch relay and the compressor clutch.
