MDX V6-3471cc 3.5L (2002)
Transmission Shift Position Indicator Lamp: Testing and Inspection
Indicator Input Test
Indicator Input Test
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before
performing repairs or service.
1. Remove the gauge assembly from the dashboard, then disconnect the A (30P) and C (14P) connectors from the gauge assembly.
2. Inspect the connectors and connector terminals to be sure they are making good contact.
3. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
4. Perform the following input test at the gauge assembly A (30P) and C (14P) connectors.
GAUGE ASSEMBLY CONNECTORS
Wire side of female terminals
5. Connect the A (30P) and C (14P) connectors to the gauge assembly.
6. If all the input tests prove OK but the indicator is faulty, replace the printed circuit board.
