MDX V6-3471cc 3.5L (2002)
Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection
1. Check the malfunction indicator lamp (MIL).
Does the malfunction indicator lamp come on?
YES - Refer to the fuel and emissions.
NO - Go to step 2.
2. Turn the ignition switch OFF.
3. Disconnect the ECT sensor 2P connector.
4. Disconnect climate control unit connector B (26P).
5. Turn the ignition switch ON (II).
6. Measure the voltage between the No. 22 terminal of climate control unit connector B (26P) and body ground.
Is there approximately 5 V?
YES - Check for loose wires or poor connections at climate control unit connector B (26P) and at the ECT sensor 2P connector. If the connections
are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control
unit.
NO - Repair open in the wire between the climate control unit and the ECT sensor.
