MDX V6-3471cc 3.5L (2002)
6. Disconnect the 2P connector (A).
Seat belt tensioner:
7. Disconnect the seat belt tensioner 2P connector (A).
8. Pull the seat belt out all the way and cut it.
9. Cut off each connector, strip the ends of the wires, and connect the deployment tool alligator clips (A) to the wires. Place the deployment tool at
least 30 feet (10 meters) away from the vehicle.
NOTE: The front passenger's airbag has four wires, two yellow and two red. Twist each pair of unlike colored wires together, and connect an
alligator clip to each pair.
10. Connect a 12 volts battery to the tool.
-
If the green light on the tool comes on, the igniter circuit is defective and cannot deploy the component. Go to Disposal of Damaged
Components.
-
If the red light on the tool comes on, the component is ready to be deployed.
