MDX V6-3471cc 3.5L (2002)
4. Check the commutator (A) surface. If the surface is dirty or burnt, resurface it with emery cloth or a lathe within the following specifications, or
recondition with #500 or #600 sandpaper (B).
5. Check the commutator diameter. If the diameter is below the service limit, replace the armature.
6. Measure the commutator (A) runout.
-
If the commutator runout is within the service limit, check the commutator for carbon dust or brass chips between the segments.
-
If the commutator runout is not within the service limit, replace the armature.
