MDX V6-3471cc 3.5L (2002)
70. Attach the yoke of a universal puller (A) to the steering gearbox mounts with bolts, then clamp the yoke in a vise with soft jaws. Do not clamp the
cylinder housing or gearbox housing in the vise.
71. Coat the inside surface of the cylinder end (A) with power steering fluid, then install the cylinder end by screwing it into the cylinder (B).
72. Remove the yoke from the gearbox, then, after tightening the cylinder end (C), stake the point of the cylinder shown (opposite from where the
stake was removed during disassembly).
73. Coat the new O-ring (A) with grease, and carefully fit it on the valve housing.
74. Apply grease to the needle bearing (B) in the gearbox housing, then install the valve body unit (C) by engaging the gears. Note the valve body unit
installation position (direction of the line connections).
75. Tighten the flange bolts (D) to the specified torque.
76. Install the return line joint (E), and tighten the 16 mm flare nut (F).
