MDX V6-3471cc 3.5L (2002)
20. Press the wheel bearing (A) out of the knuckle (B) using the special tools and a press.
21. Press the wheel bearing inner race (A) from the hub (B) using the special tool, a commercially available bearing separator (C), and a press.
22. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
23. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tool, and a press. Be careful not to
damage the sleeve of the pack seal.
24. Install the circlip (A) securely in the knuckle (B).
25. Install the splash guard (C), and tighten the screws (D).