MDX V6-3471cc 3.5L (2002)
11.
Clean the drain plug, then reinstall it with a new 18 mm sealing washer. Torque the drain plug to 47 N.m (35 lb-ft).
NOTE:
Some early models may use a 20 mm sealing washer.
12.
Fill the differential with VTM-4 differential fluid until the fluid level reaches the bottom of the filler hole.
13.
Reinstall the filler plug with a new 20 mm sealing washer. Torque the filler plug to 47 N.m (35 lb-ft).
14.
Test-drive the vehicle in a figure-eight pattern to make sure the noise and judder are gone. Accelerate at the start of each circle to ensure the
clutches engage and disengage.
NOTE:
You may need to do up to 10 patterns to get rid of the noise and judder.
Disclaimer
