MDX V6-3471cc 3.5L (2002)
Clutch Control Solenoid Valve: Testing and Inspection
A/T Clutch Pressure Control Solenoid Valves A and B Test
Test
1. Disconnect the 2P connectors from A/T clutch pressure control solenoid valves A and B.
2. Remove the A/T clutch pressure control solenoid valves A and B.
3. Measure the A/T clutch pressure control solenoid valves A and B resistances at each solenoid valve connector.
STANDARD: About 5.0 Ohms
4. If the resistance of either solenoid is out of standard, replace A/T clutch pressure control solenoid valves A and B.
5. Connect the No. 1 terminal of A/T clutch pressure control solenoid valves A and B to the battery positive terminal, and connect the No. 2 terminal
to the battery negative terminal. A clicking sound should be heard. Remove A/T clutch pressure control solenoid valves A and B if no sound is
heard.
6. Check the fluid passage of the A/T clutch pressure control solenoid valves for dust and dirt, and clean the passage if necessary.
7. Connect the No. 1 terminal of A/T clutch pressure control solenoid valves A and B to the battery positive terminal, and connect the No. 2 terminal
to the battery negative terminal. Make sure A/T clutch pressure control solenoid valves A and B move.
8. Disconnect one of the battery terminals and check valve movement.
NOTE: You can see valve movement through the fluid passage in the mounting surface of the assembly body (C).
9. If either valve binds or moves sluggishly, or if the solenoid does not operate, replace A/T clutch pressure control solenoid valves A and B.
