MDX V6-3471cc 3.5L (2002)
10. Glue the rubber dam (A) to the inside surface of the glass (B) as shown:
-
Be sure both ends of the rubber dam line up with the alignment marks (C).
-
Be careful not to touch the glass where adhesive will be applied.
11. Glue the clips (A) to the inside face of the quarter glass (B) as shown. Be careful not to touch the quarter glass where adhesive will be applied.
12. With a sponge, apply a light coat of glass primer to the edge of the glass (A) and along the rubber dam (B) as shown, then lightly wipe it off with
gauze or cheesecloth:
-
Do not apply body primer to the quarter glass, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.