MDX V6-3471cc 3.5L (2002)
11. Glue the upper rubber dam (A), side rubber dam (B), lower rubber dam (C), clips (D), and dashboard seal (E) to the inside face of the windshield
(F) as shown:
-
Be sure the side rubber dam, lower rubber dam and dashboard seal line up with the alignment marks (G).
-
Be careful not to touch the windshield where adhesive will be applied.
12. Apply primer (3M N-200, or equivalent) to the edge of the windshield between the alignment marks (A). Be careful not to touch the windshield
where adhesive will be applied.
13. Glue the molding (A) with adhesive tape (B) to the edge of the windshield (C):
-
Be sure the alignment mark (D) of the molding lines up with the alignment mark (E) of the windshield.
-
Be careful not to touch the windshield where adhesive will be applied.