NSX-T V6-3.0L DOHC (VTEC) (1998)
17. Loosen the idler pulley center nut and adjusting nut, then remove the Air Conditioning (A/C) compressor belt.
18. Remove the crankshaft pulley.
19. Remove the rubber seal from the adjusting bolt, then remove the middle covers and lower cover.
20. Loosen the adjusting bolt 180° turn. Push the tensioner to remove tension from the timing belt, then retighten the adjusting bolt.
21. Remove the timing belt from the pulleys.
INSTALLATION
Install the timing belt in the reverse order of removal; Only key points are described here.
NOTE: Clean the middle and lower covers before installation.