NSX-T V6-3.0L DOHC (VTEC) (1998)
1. Set the timing belt drive pulley so that the No. 1 piston is at Top Dead Center (TDC). Align the Triangle mark on the teeth side of the timing belt
drive pulley to the Downward pointer on the oil pump.
2. Set the front camshaft pulleys so that the No. 1 piston is at TDC. Align the TDC marks on the front exhaust camshaft pulley and front intake
camshaft pulley to the pointer on the back cover.
3. Set the rear camshaft pulleys so that the No. 1 piston is at TDC. Align the TDC mark on the rear intake camshaft pulley to the pointer on the back
cover. Align the rear exhaust camshaft pulley one half tooth clockwise past TDC.
4. Install the timing belt tightly in the sequence shown.
(1) Timing belt drive pulley (crankshaft) -> (2) Adjusting pulley -> (3) Front exhaust camshaft pulley -> (4) Front intake camshaft pulley -> (5)
Water pump pulley -> (6) Rear intake camshaft pulley -> (7) Rear exhaust camshaft pulley.
NOTE: Make sure the timing belt drive pulley and camshaft pulleys are at TDC.