NSX-T V6-3.0L DOHC (VTEC) (1998)
Carrier Bearings: Adjustments
NOTE: If any of the items listed are replaced, the bearing preload must be adjusted.
-
TRANSMISSION HOUSING
-
TORQUE CONVERTER HOUSING
-
DIFFERENTIAL
-
TAPERED ROLLER BEARING and OUTER RACE
-
75 mm THRUST SHIM
-
90 mm WASHER
-
OIL GUIDE RING
1. Remove the bearing outer race and 75 mm thrust shim from the transmission housing by prying up on the bearing outer race or by heating the
housing to about 212°F (100°C).
CAUTION: Do not reuse the thrust shim if the outer race was pried out.
NOTE:
-
If the outer race was removed by heating the case, let the transmission cool to room temperature before adjusting the bearing preload.
-
Do not heat the transmission housing in excess of 212°F (100°C).
-
Replace the bearing with a new one whenever the outer race is replaced.
-
Repeat on the torque converter side.