NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4359004.png)
NOTE: Check the reshaped parts for cracks.
6. Set the new dashboard upper.
-
Drill the 8-10 mm (5/16"-3/8") holes for plug welding in the welding flange of the new dashboard upper.
-
Remove the undercoat from the both sides of the welding section and expose the aluminum alloy base using a disc sander.
WARNING: To prevent eye injury wear goggles or safety glass whenever sanding, cutting or grinding.
-
Remove the paint film from the welding section of the body, and clean oil contaminations with a shop towel soaked with wax and grease
remover.
-
Before setting the new dashboard upper remove the oxide film from the welding section of the replacement part and body using a stainless
steel wire brush.
-
Set the dashboard upper and clamp it with the vise-grips and pliers.
-
Install the windshield and check for proper installation and alignment.
-
Check the body dimensions.
-
NSX-T (open top): Keep the body level. Check the front roof rail and door opening position using the roof panel positioning jig recommended.
7. Tack weld the dashboard upper. Plug weld the clamped sections.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
8. Remove the vise-grips and pliers and install the front fender, windshield and hood. Check for difference in level and clearance.
9. Perform the main welding.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
