NSX-T V6-3.2L DOHC (VTEC) (1997)
15. Weld the new side panel.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, remove the oxide film from the welding sections using a stainless steel wire brush.
-
The applicable welding methods are MIG welding, plug welding, and fillet welding.
-
Attach a tab to the butt welding section as shown and weld.
-
Preheating effect can be obtained by attaching a tab to the butt welding section.
16. Finish the welding area.
-
Roughly grind the welds with a disc grinder. Be sure to leave the finishing allowance this time.
-
Finish grind the finishing allowance with a disc sander until it is smooth.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Finish the butt weld by removing the tab.
-
Take care not to grind the aluminum alloy base while roughly grinding the welds.
-
Take care not to grind excessively.
-
Do not press on the sanding tools excessively. If the disc face is clogged with the aluminum alloy particles, replace with a new disc.
-
Finish the butt welded door opening of the outer panel with a disc sander and putty.
17. Apply the sealer
Apply sealer to each mating surface.
18. Apply the paint.
See Paint Repair section.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
19. Apply the undercoat
Undercoat the front floor, etc, and apply anti-rust agent to inside of the welding section of the rear side frame, side sill and center pillars, etc.
20. Install the related parts.
-
Install in the reverse order of removal.
-
Adjust the rear hatch and door strikers, and check the lock operation.
21. Check and clean
-
Check the lights, etc. for proper operation.
-
Clean the passenger compartment.
NSX-T (open top):
-
Set the roof panel, then secure the roof panel by turning the roof side lock handles.
-
Make sure the roof side locks are locked securely.
-
Check for water leaks.