NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Strike a punch in the center of the spot welds to the side panel and center pillar upper extension.
-
Drill the spot welds using a 10 mm (3/8") spot cutter.
-
Strike a punch in the center of the spot welds to the front pillar, side sill, and rear pillar.
-
Drill the spot welds using a 10 mm (3/8") spot cutter.
-
Grind the MIG welding section using a rotary cutter.
-
Remove the remaining welding flanges using a chisel.
-
Remove the burrs from the drilled section using a disc sander.