NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4368011.png)
Remove the jig and install the front and rear lock receivers, then check the clearance and level differences of the roof panel and roof rails.
9. Perform main welding.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, perform the trial welding following the welder manufacturer's instructions.
-
Remove the oxide film from the welding section using a stainless steel wire brush.
Coupe:
-
Weld the roof side rail and roof panel.
NSX-T (open top):
