NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4371008.png)
NOTE:
-
Do not press on the seal yet to make the adhesive stick.
-
Install the roof portion in the same way as the pillar portion.
-
Before installing the roof portion of the front pillar seal, lubricate the lips with soapy water.
18. Carefully pull the separator away from the butyl tape at the roof portion of the front pillar seal.
19. Press on the roof portion of the butyl tape to make the adhesive stick.
NOTE: Do not press on the front pillar seal portion of the seal yet.
20. Scrap or wipe the excess sealant off with a putty knife or towel.
