NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-3120001.png)
Brake Caliper: Testing and Inspection
Rear
Inspect caliper components as directed by the diagram.
WARNING:
-
Use an Occupational Safety and Health Administration (OSHA)-approved vacuum cleaner to avoid breathing brake dust.
-
Contaminated brake discs or pads reduce stopping ability.
CAUTION:
-
Never use an air hose or dry brush to clean brake assemblies.
-
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
-
Always use DOT 3 Brake Fluid. Using a non-DOT 3 brake fluid can cause corrosion and decrease the life of the system.
-
Replace all rubber parts with new ones whenever disassembled.
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
To prevent spills, cover the hose joints with rags or shop towels.
-
Before reassembling, check that all parts are free of dust and other foreign particles.
