NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4383001.png)
Cruise Control Switch: Testing and Inspection
Set/Resume Switch Test
CAUTION: Before disconnecting any part of an SRS wire harness, connect the short connectors.
SET/RESUME Switch Test
1. Disconnect the cable reel harness and main harness 6P connector. Connect test harness C only to the cable reel harness side of the 6P connector.
SET/RESUME Switch Test
2. Check for continuity between the terminals in each switch position according to the table.
^ If there is no continuity, check the cable reel.
^ If OK, go to step 3.
