NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-1011002.png)
NOTE
-
Guide the piston carefully to prevent damage.
-
Fit long rubber hoses (about 30 cm long) to connecting rod bolts to protect the crankshaft.
-
Install the pistons after setting the crankshaft to BDC for each cylinder.
-
Line up the marks when installing connecting rod cap.
5. Check the rod bearing clearance with plastigage, then torque the connecting rod cap nuts.
NOTE: Reference numbers on connecting rods are for big-end bore tolerance and do NOT indicate the position of piston in engine.
Connecting Rod Cap Nut Torquing Method
1) Torque the connecting rod cap nut to 20 Nm (14 ft. lbs.) with a beam-type torque wrench.
2) Install a torque angle gauge to the cap nut, then turn the cap nut 116 degrees.
