NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-1585001.png)
Fuel Pressure Release: Service and Repair
Before disconnecting fuel pipes or hoses, release pressure from the system by loosening the 6 mm service bolt on top of the fuel filter.
WARNING:
-
Do not smoke while working on the fuel system. Keep open flames or sparks away from your work area.
-
Be sure to relieve fuel pressure while the ignition switch is off.
1. Disconnect the battery negative cable from the battery negative terminal.
2. Remove the fuel fill cap.
3. Place a box end wrench on the 6 mm service bolt at the fuel filter, and hold the special banjo bolt with another wrench.
4. Place a rag or shop towel over the 6 mm service bolt.
5. Slowly loosen the 6 mm service bolt one complete turn.
NOTE:
-
A fuel pressure gauge can be attached at the 6 mm service bolt hole.
-
Always replace the washer between the service bolt and the special banjo bolt whenever the service bolt is loosened.
-
Replace all washers whenever the bolts are removed.
