NSX-T V6-3.2L DOHC (VTEC) (1997)
SRS Indicator Light: Testing and Inspection
Mode B: Short to Driver's or Passenger's Airbag Inflator Body.
SRS Indicator Light Stays On Continuously
Mode B: Short to driver's or passenger's airbag inflator body.
-
Short to driver's or passenger's seat belt tensioner.
-
Short in dash sensor.
-
Open in both safing sensor contacts.
1. Before disconnecting any part of the SRS wire harness, install the short connectors (RED).
Mode B
2. Connect test harness B between the SRS unit and SRS main harness 18P connector.
Mode B
3. Reconnect the driver's airbag connector. Check continuity between the No. 1 terminal and body ground, and between the No. 7 terminal and body
ground.
-
If there is continuity, go to step 7.
-
If there is no continuity, go to step 4.
Mode B
4. Reconnect the passenger 5 airbag connector. Check continuity between the No. 2 terminal and body ground, and between the No. 8 terminal and
body ground.
-
If there is continuity, go to step 11.
-
If there is no continuity, go to step 5.