NSX-T V6-3.2L DOHC (VTEC) (1997)
SRS Indicator Light: Testing and Inspection
Mode F: Open In Passenger's Airbag Inflator
SRS Indicator Light Stays On Continuously
Mode F: Open In Passenger's Airbag Inflator
1. Before disconnecting any part of the SRS wire harness, install the short connectors (RED).
Mode F
2. Connect test harness B between the SRS unit and SRS main harness 18P connector.
Mode F
3. Reconnect the passenger's airbag connector. Measure the resistance between the No. 2 terminal and the No. 8 terminal.
-
If resistance is more than 0.2 K-ohms, go to step 4.
-
If resistance is less than 0.2 K-ohms, the SRS unit is faulty. Substitute a known-good SRS unit, and recheck the voltages according to the
chart.
Mode F
4. Disconnect the passenger's airbag 3P connector from the SRS main harness, then connect test harness C to the passenger's airbag side of the
connector.